Wire Wonder's adjustable pegs are what turn a cable box into a cable management system. Here's where the idea came from, how the pegs attach, and how to arrange them for anything from two cords to a full network install.

Inspired by the pegboard

The Wire Wonder peg system was inspired by a simple, proven tool: the traditional pegboard. Pegboards are a fixture in manufacturing plants, vehicle service bays and construction shops, and they're a core part of 5S workplace organization (Sort, Set in order, Shine, Standardize, Sustain). Every tool has a place, everything is visible, and anything can be moved when the job changes.

A traditional pegboard: every tool has its own place, and any hook can be moved. Wire Wonder applies the same idea to cables.

Wire Wonder brings that same organizing idea to cables. Instead of stuffing cords into a box and closing the lid, you give each cable its own path, so it stays untangled, easy to trace, and easy to remove.

36 peg positions in a grid

Inside the Wire Wonder backbox is a grid of 36 peg positions. Wire Wonder includes 36 pegs, so you can place pegs wherever a cable needs to turn, loop or stay put, and leave the rest of the grid open.

The Wire Wonder backbox with its grid of 36 peg positions.

Attach or remove a peg with a 90-degree twist

Each peg locks into the grid with a quarter turn. No tools are needed:

1. Place the peg into an open position on the grid.
2. Twist it 90 degrees to lock it in place.
3. To move it, twist it back 90 degrees, lift it out, and place it somewhere else.

A Wire Wonder peg attaching and detaching with a 90-degree twist. Watch it as a YouTube Short.

Close-up of a Wire Wonder adjustable peg.

From a few cords to a full setup

Start with just the pegs you need and add more as your setup grows. A good rule of thumb is two pegs per cable: wind the extra length in a loop between them so each cord stays separate.

Left: 2 cables wound around 4 pegs. Right: 3 cables around 6 pegs.

Left: 4 cables around 8 pegs. Right: 5 cables around 10 pegs, each kept separate for easy removal.

Keeping cables separated pays off later. When you replace a monitor or move a charger, you can lift out one cord without untangling the rest. Keeping power cords apart from data cables also helps reduce interference between them.

More than cable winding

Make a shelf for a router and power strip

Pegs can be arranged to form a "shelf" that holds a wireless router, modem or power strip in place inside the box. Wire Wonder's plastic is virtually transparent to Wi-Fi signal, so a router can stay hidden without losing coverage.

Pegs used as a shelf for a wireless router and a power strip.

Prevent over-bending and kinks

Winding a cable around a rounded peg gives it a gentle curve instead of a sharp fold. That protects network cables from over-bending and kinking, which matters for keeping data connections reliable.

Pegs keep cables in a gentle curve to prevent over-bending and kinks.

Snap the cover on

When everything is in place, the snap-on cover hides it all. Need to add or change a cable later? Pop the cover off, twist a peg to a new spot, and snap it back on.

Wire Wonder with the snap-on cover in place.

See Wire Wonder in five real setups: a wall outlet, a TV, a standing desk and two home offices.

Quick answers

• How many pegs come with Wire Wonder? 36, one for every position in the grid.
• How do the pegs attach? Place a peg in the grid and twist it 90 degrees to lock it. Twist it back to remove it.
• Do I need tools? No. The pegs attach and detach by hand.
• How many pegs per cable? Usually two: wind the cable's extra length in a loop between them.
• Can the pegs hold equipment? Yes. Arrange them as a shelf for a router, modem or power strip.